ClimateRight CR-2550 El manual del propietario descargar pdf (Pagina 88)

Engines & Controls

3-19

To start the engine the remote control handle must

be positioned in neutral.

Next, position the lanyard stop switch to the “run”

position. If it is in the off position the engine will

crank over in neutral but it will not start. Always

ensure the lanyard stop switch is attached to a

secure piece of clothing such as a belt. For more

information, refer to the safety lanyard section

later in this chapter.

Turn the ignition switch to the start

position. The engine starter will

crank over the engine which will

allow it to start. Note there is a 20

amp breaker located next to the

ignition switch.

The breaker protects the ignition

switch circuitry against any overload

conditions or voltage surges. Should

an overcurrent situation develop the key switch will not engage the

starter when it is in the “start” position.

DTS Remote Control- Engine Start-Up Procedure

20 Amp Breaker

Engines & Controls

3-19

To start the engine the remote control handle must

be positioned in neutral.

Next, position the lanyard stop switch to the “run”

position. If it is in the off position the engine will

crank over in neutral but it will not start. Always

ensure the lanyard stop switch is attached to a

secure piece of clothing such as a belt. For more

information, refer to the safety lanyard section

later in this chapter.

Turn the ignition switch to the start

position. The engine starter will

crank over the engine which will

allow it to start. Note there is a 20

amp breaker located next to the

ignition switch.

The breaker protects the ignition

switch circuitry against any overload

conditions or voltage surges. Should

an overcurrent situation develop the key switch will not engage the

starter when it is in the “start” position.

DTS Remote Control- Engine Start-Up Procedure

20 Amp Breaker

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 348 349

Comentarios a estos manuales

Sin comentarios