ClimateRight CR-2550 El manual del propietario descargar pdf (Pagina 239)

CHAPTER 6

6-96

In a properly operating system, the stored vacuum will “leak” down

betw

een ﬂ ushes, causing the vacuum pump to run for a short period.

This is normal. The pump should not run for more than once every

(3) hours after the last ﬂ ush.

To operate the Vacuﬂ ush® head:

1. Activate the fresh water system switch at the helm

since the fresh water tank is the main water source for

the Vacuﬂ ush® system.

2. Activate the vacuum pump switch located at the head

aft wall. This will activate the vacuum generator pump

which diminishes the size of the waste as it enters the

holding tank. Remember to tell passengers using the

toilet system to activate the vacuum pump switch be-

fore ﬂ ushing the toilet or the waste entering the holding tank will not

be diminished in size.

3. Lift the toilet lever until the desired water level is reached. The sys-

tem requires more water for solid over liquid

waste. See ﬁ gure 1.

4. To ﬂ ush the toilet, press the ﬂ ush lever

in one swift motion down to the ﬂ oor un-

til contents in the bowl disappear. A distinct

popping noise is normal when ﬂ ushing ac-

tion begins and the vacuum seal is broken.

Hold the lever down for at least 3 seconds.

If ﬂ ush lever is accidentally released before

waste clears the bowl, do not try to ﬂ ush toi-

let again until vacuum pump stops running.

A small amount of water should remain in

the bowl after ﬂ ushing. See ﬁ gure 2.

Vacuum Pump

Switch