ClimateRight CR-2550 El manual del propietario descargar pdf (Pagina 158)

Equipment Operation

6-15

The cockpit cover installs over the windshield and snaps to the deck.

To install the cockpit cover, note that at the bow end of the cover there

is a seam on the inside which separates the port and starboard sides.

Align this seam with the center snap below the windshield. Complete

snapping the canvas to the outside and then down each gunnel to

admidships.

This type of canuvas cover requires several cockpit poles. Their purpose

is to keep the canvas tight and water out of the interior. Notice on the

underside of the cover there are areas of reinforced canvas material.

These are for the cockpit cover poles. Each pole is adjustable by

opening it to the desired length and tightening the thumb screw. You

may ﬁ nd it helpful to mark the poles so you can install them in the

same location each time.

The cockpit cover is not designed to be used at highway speeds.

Do not tow your Regal boat with a cockpit cover as personal

injury and/or property damage could result. Purchase a suitable

travel cover designed for highway use before towing your vessel. They

can be ordered from your authorized Regal dealer.

Cockpit Cover

TONNEAU COVER

COCKPIT COVER